Battlefrontmodels

1/16 SCALE RC TANK MODELS

PHOTO BOOTH

"What a Good Idea"

Two views of the side upper rails complete with fittings.

Shown are the Upper rails fully assembled ready for the

uprights to be added.

Shown assembled with upright piping.

This view above showing the lamp support frame.

ABOVE: Joe Canestrari's version.

BELOW: Are a few photo's taken by Joe to show the variation

in lighting that can be achieved with this setup.

The three photo's below are of David's frame and the last one

shows the booth dis-assembled.

Also you will require three lamps the type with crocodile clips these are attached

to the wooden support frame to suit your lighting requirements, also a Camera tripod

 some Velum paper, Mylar or Kodatrace to use as a light di-fuser.

 Joe has used ordinary computer printing paper (not shown) as a di-fuser which

 is excellent but could be a fire hazzard if the lamps are placed too close.

..........................................................................................................

We have to thank both Joe Canestrari from Quebec, Canada and

David Waples of Westminster, Colorado USA for this unique

idea for a collapsible Photo Booth ideal for those

Tanker Photo Moments.